Tackling Hazy Water Hassles With Absolute Clarity<\/em><\/p>\n
When it comes to cloudy wastewater, there are any number of reasons you can find yourself in a fog. From residual emulsified oil and surfactants to overdosing on polymers and coagulants, 艳照门视频\u2019s wastewater treatment technical team can help you diagnose and treat the problem.\u00a0 What are some of the reasons for the cloudy wastewater?<\/p>\n
\n
\n
\n
Residual Emulsified Oil<\/strong> \nWhen water contains emulsified oil, the oil can carry over if it isn\u2019t tied up to the coagulant you are using. A proprietary coagulant that has a calcium, magnesium or iron component can help break the interface of the emulsion thus clearing up the water.<\/li>\n
Residual Surfactants<\/strong> \nHazy effluent may be caused by residual surfactants that potentially show up when it reaches a cloud point or interacts with other waste rinses. Choose the best coagulant based in iron or organic components to the formulation. The following would be a good starting point:<\/li>\n<\/ul>\n<\/li>\n<\/ul>\n
\n
\n
\n
\n
\n
Over Dosing on the Coagulant<\/strong> \nThe use of a coagulant to solve a hazy condition in wastewater should be used at the dose to solve the worst condition. Too much organic components can also lead to haziness. When jar testing, it is recommended to bracket the high and low dose to find the best results that take care of the haziness.<\/li>\n
Over Dosing on an Emulsion-Based Polymer<\/strong> \nPolymers are typically added as a 0.1% dilution made up in a day tank prior to use. This diluted polymer is added at 5-10 ppm depending on the solids you are trying to mass together. If the flow rate goes down but the polymer dose stays up this condition can result in over dosing of the polymer. The polymer addition should be tied into the flow rate \u2013 proportionally. If this occurs cut the dosing back on the polymer.<\/li>\n
Adding the Wrong Polymer<\/strong> \nPolymers are characterized by their iconicity, charge density and molecular weight. Jar testing can determine the best polymer to use for your solids. If the polymer is not effective, you may be using the wrong polymer. Changing the dosage doesn\u2019t solve the problem either; the polymer can also lead to haziness but will not be solved by cutting back on the dosing.<\/li>\n<\/ul>\n<\/li>\n<\/ul>\n<\/li>\n<\/ul>\n